Examples of RF PCB Design
4 Channel UHF DVB receiver. The four channels can be seen, and the RF feed point in the centre.
2 layers.
GPS LNA employing all printed passive components. The GPS patch antenna is fitted to the other side of the PCB.
2 layers.
Portable 121.5 MHz VHF direction finder PCB employing three internal offset striplines.
4 layers – controlled impedance build.
UHF TV modulator PCB with transmission-line type front-end balun (UHF feed through) fabricated in the PCB.
2 layers
UHF 1W synthesised transmitter (ETS-330-220-1 compliant) employing printed inductors.
4 layers – high density.
PMR 446 transceiver development PCB designed by Tim before forming RadioCAD.
2 layers.
Automotive low-power +5 and +12V switched mode PSU. This design employs planar magnetics.
2 layers.
Simple ADSL splitter PCB
1 layer